My Two-Box Dive Gear System

Disclosure: This is an independent account of equipment I use or have used. I work in the diving industry and sell some of the brands or products mentioned, but I am not paid or sponsored to promote them and none of the equipment discussed here was supplied to me free. My preferences are personal conclusions from use, not universal buying advice.

Safety note: Equipment articles cannot replace formal scuba or technical-diving training, a manufacturer manual, a gas plan or a dive plan. Configuration choices must make sense for the diver, environment, team and training involved.

Why two stackable plastic boxes beat one enormous bag for me.

Why two stackable plastic boxes beat one enormous bag for me. The dive starts long before the water, and a good transport and cleaning system can save more energy than another expensive piece of gear.

The workflow

I transport my personal dive gear in two stackable plastic boxes: one large and one smaller. The large box carries the exposure suit, boots and BCD. The smaller box carries fins, regulators, masks and accessories.

The smaller box becomes denser and heavier, but separating the bulky wet items makes the complete system easier for me to move and organise. Everything has a predictable home, which makes forgotten equipment easier to notice before leaving for the site.

The practical point

A simple workflow is valuable because it makes the correct behaviour easy to repeat after every dive.

Why two cheap boxes beat one enormous dive bag for me

The large box carries bulky but relatively light wet gear: BCD, suit and boots. The smaller one carries compact dense equipment such as regulators, fins and accessories. Stacking them keeps transport simple and separates the objects I want to rinse first.

This system is not glamorous and that is exactly why I like it. It is easy to replace, easy to clean, and I can see what is missing before I leave.

The dive starts before the water and ends after it

Transport, rinsing and storage rarely look glamorous in equipment discussions, yet they determine how much effort a setup creates and how well equipment ages. My system is intentionally simple: two stackable plastic boxes. The larger box carries the suit, boots and BCD; the smaller box carries denser equipment such as regulators, fins and accessories. The separation makes the load more manageable and means I am not moving one enormous container every time.

The large box has a small drain valve in the bottom. At home it becomes a rinse tank. I fill it with fresh water, rinse the suit, BCD and boots, then work through the remaining equipment before opening the valve and draining it. The box therefore earns its place twice: transport and cleaning.

Cylinders need their own logistics

Aluminium S80s may feel beautifully neutral underwater, but they remain heavy projectiles in a vehicle. I designed and 3D-printed supports to stop them rolling around. That is a small example of the kind of equipment problem I enjoy solving: not buying another dive gadget, but making the complete process safer and easier from home to water and back again.

Rinsing is not servicing

Fresh-water rinsing removes salt and contamination; it does not replace inspection, scheduled servicing or correct drying and storage. Regulators should be handled so water is not encouraged into places it should not go, suits need to dry appropriately, and batteries/electronics deserve their own preparation. The principle is simple: maintenance begins with understanding what the equipment is designed to tolerate.

Good logistics buy more diving energy

Every unnecessary carry, tangled wet bag and rolling cylinder consumes attention before the dive or patience afterwards. I prefer solving those problems once with boxes, supports and a rinse routine. The reward is not a prettier garage; it is arriving at the water with more energy for the actual dive and getting home with equipment that is easier to maintain.